收藏本站
SOT Temperature Sensor with
Multidrop Single-Wire Digital Interface
_______________Detailed Description
Table 1. Time-Select Pin Configuration
The MAX6575L/H low-cost, low-current (150μA typ)
temperature sensor is ideal for interfacing with micro-
controllers or microprocessors. The MAX6575L/H is a
TIME-SELECT PINS
TIMEOUT MULTIPLIERS
(μs/°K)
monostable, externally triggered temperature sensor
that uses a Temp → Delay conversion to communicate
with a μP over a single I/O line. Time-select pins (TS1,
TS0) permit the internal temperature-controlled oscilla-
tor (TCO) to be scaled by four preset timeout multipli-
ers, allowing eight separate temperature sensors to
share one I/O line. Different sensors on the same I/O
TS1
GND
GND
V DD
V DD
TS0
GND
V DD
GND
V DD
MAX6575L
5
20
40
80
MAX6575H
160
320
480
640
line will use different timeout multipliers to avoid over-
lapping signals.
Operating the MAX6575L/H
Figure 1 illustrates the timing for the MAX6575L/H.
When the device is powered up, it assumes a ready
state where it awaits an external trigger at the I/O pin.
The I/O pin of the MAX6575L/H has an open-drain out-
put structure that requires a pull-up resistor to maintain
the proper logic levels. Once the I/O pin is pulled low
and then released, control of the I/O pin is transferred
to the MAX6575L/H. The temperature conversion
begins on the falling edge of the externally triggered
pulse. The I/O line is pulled low at a later time. That time
is determined by the device temperature and the Time
Select pins (TS1, TS0). The I/O line remains low for
mum delay of 520ms, at which point it will again be in a
ready state awaiting a start pulse.
Definition of Terms:
t RESET : Time I/O must be externally pulled low to guar-
antee the MAX6575L/H is in a ready state
awaiting external trigger. (Part will assume a
ready state after 520ms without a reset pulse.)
t SETUP : Time I/O must be high prior to a start pulse.
t START : Trigger pulse which starts the on-chip timing
sequence on its falling edge.
t Dx : Timing delay between the falling edge of the
start pulse and the falling edge initiated by
CHIP#x.
5Tμs, where T is the temperature in degrees Kelvin. The
t Lx :
I/O pulse low time (5Tμs).
temperature of the device is represented by the edge-
to-edge delay of the externally triggered pulse and the
falling edge of the subsequent pulse originating from
the device. The device can be manually reset by
pulling the I/O line low for more than t RESET (16ms
max). The device will automatically reset after a maxi-
t READY : Time after falling edge of start pulse when the
MAX6575L/H will reset itself and await the next
external trigger.
The temperature, in degrees Celsius, may be calculat-
ed as follows:
T(°C) = [t Dx (μs) / timeout multiplier(μs/°K)] - 273.15°K
APPLIED START
CHIP# 1
CHIP# 2
CHIP# 3
CHIP# 4
t SETUP
t START
PULSE
t L1
RESPONSE
t L2
RESPONSE
t L3
RESPONSE
t L4
RESPONSE
t RESET
t D1
t D2
t D3
t D4
t READY
Figure 1. Timing Diagram
4
_______________________________________________________________________________________
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
MAX6577ZUT-T IC TEMP SNSR PER/FREQOUT SOT23-6
MAX66000K-000AA+ IC RFID UID 64BIT TYPE B KEY FOB
MAX66020K-000AA+ IC RFID UID 1KB TYPEB MEM KEYFOB
MAX66040K-000AA+ ISO CARD SECURE MEMORY
MAX6605MXK/V+T IC TEMP SENSOR ANLG LP SC70-5
MAX6608IUK+T IC TEMP SENSOR ANLG SOT23-5
MAX66100K-000AA+ IC RFID UID 64BIT TYPE B KEY FOB
MAX6611AUT+T IC TEMP SENS LOW PWR SOT23-6
相关代理商/技术参数
MAX6575HZUT-T 功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6575LZUT 制造商:Maxim Integrated Products 功能描述:SINGLE-WIRE DIGITAL TEMPERATURE SEN - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:
MAX6575LZUT+ 制造商:Maxim Integrated Products 功能描述:TEMP SENSOR DGTL 1-WIRE 6PIN SOT-23 - Bulk
MAX6575LZUT+T 功能描述:板上安装温度传感器 Temperature Sensor w/Multidrop Int RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6575LZUT-T 功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6576LZUT 制造商:Maxim Integrated Products 功能描述:SINGLE-WIRE DIGITAL TEMPERATURE SE - Rail/Tube
MAX6576LZUT+ 制造商:Maxim Integrated Products 功能描述:SINGLE-WIRE DIGITAL TEMPERATURE SE - Rail/Tube
MAX6576LZUT+T 制造商:Maxim Integrated Products 功能描述:SINGLE-WIRE, DIGITAL TEMPERATURE SENSOR WITH - Tape and Reel